obsproc的domain设置

xxxxxxxxxxxxxxx

在进行wrfda的三维变分时，在obsproc这一步，应该怎么进行domain的设置。

我的区域是102-138°E,6-38°N 。按照下边的设置，结果都out domain了。 IPROJ 3 PHIC 22 XLONC 100.5 TRUELAT1 6 TRUELAT2 38 MOAD_CEN_LAT 22 STANDARD_LON 100.5

名表文件里相关说明如下：

&record7
IPROJ	Map projection (0 = Cylindrical Equidistance, 1 = Lambert Conformal, 2 = Polar stereographic, 3 = Mercator)
PHIC	Central latitude of the domain
XLONC	Central longitude of the domain
TRUELAT1	True latitude 1
TRUELAT2	True latitude 2
MOAD_CEN_LAT	The central latitude for the Mother Of All Domains
STANDARD_LON	The standard longitude (Y-direction) of the working domain.
&record8
IDD	Domain ID (1=< ID =< MAXNES), Only the observations geographically located on that domain will be processed. For WRF application with XLONC /= STANDARD_LON, set IDD=2, otherwise set 1.
MAXNES	Maximum number of domains as needed.
NESTIX	The I(y)-direction dimension for each of the domains
NESTJX	The J(x)-direction dimension for each of the domains
DIS	The resolution (in kilometers) for each of the domains. For WRF application, always set NESTIX(1),NESTJX(1), and DIS(1) based on the information in wrfinput.
NUMC	The mother domain ID number for each of the domains
NESTI	The I location in its mother domain of the nest domain's low left corner -- point (1,1)
NESTI	The J location in its mother domain of the nest domain's low left corner -- point (1,1). For WRF application, NUMC(1), NESTI(1), and NESTJ(1) are always set to be 1.

xxxxxxxxxxxxxxx

问题解决了 这个设置要和wps里geogrid的设置一致