- 积分
- 1163
- 贡献
-
- 精华
- 在线时间
- 小时
- 注册时间
- 2020-6-9
- 最后登录
- 1970-1-1
|
发表于 2024-1-5 17:43:48
|
显示全部楼层
请教一下ncview的./configure步骤报错：
checking for nc-config... no
-----------------------------------------------------------------------------------
Error, nc-config not found or not executable. This is a script that comes with the
netcdf library, version 4.1-beta2 or later, and must be present for configuration
to succeed.
If you installed the netcdf library (and nc-config) in a standard location, nc-config
should be found automatically. Otherwise, you can specify the full path and name of
the nc-config script by passing the --with-nc-config=/full/path/nc-config argument
flag to the configure script. For example:
./configure --with-nc-config=/sw/dist/netcdf4/nc-config
Special note for R users:
-------------------------
To pass the configure flag to R, use something like this:
R CMD INSTALL --configure-args="--with-nc-config=/home/joe/bin/nc-config" ncdf4
where you should replace /home/joe/bin etc. with the location where you have
installed the nc-config script that came with the netcdf 4 distribution.
-----------------------------------------------------------------------------------
该怎么解决呢 |
|
窥视卡
雷达卡
显身卡
楼主