wrf2grads 垂直方向设置详细介绍

cibapotato

7.   the vertical grid

          Specifying 0 means output the model grid unchanged
          (i.e., sigma surfaces are flat in grads).  
          In this case NO extra information is needed, and the remainder
          of the control file will be ignored.

          Specifying -1 causes the variables to be interpolated to
          a grid defined by the heights in the column at the lowest
          terrain point in the domain.  
          In this case NO extra information is needed, and the remainder
          of the control file will be ignored.

          Specifying  1 will result in interpolation to either
          "z" or "p". (The code will expect 3 blank lines between
          the "1", and the first level to be interpolated to - do no
          remove any of these lines).
          To interpolate data to height/pressure levels, simply list
          the levels you are interested in from ground to top.
          Pressure level data should be in mb and height level data
          in km. Depending on the values, the code will figure our
          if it needs to interpolate to height/pressure levels.

kongfeng0824

哇，不知道有中文版的手册吗？

mofangbao

怎么感觉是纯粹在刷帖子 楼主能否加点说明?还是第7点 看上去就是从某个手册里面复制的一段话

cibaouc

嗯，挺有帮助的，谢谢楼主