cartopy安装失败

sadf

在pycharm里将cartopy添加到interpreter出现这种情况，有没有朋友知道怎么解决啊

sadf

Collecting Cartopy
  Using cached Cartopy-0.20.2.tar.gz (10.8 MB)
  Installing build dependencies: started
  Installing build dependencies: finished with status 'done'
  Getting requirements to build wheel: started
  Getting requirements to build wheel: finished with status 'error'

  error: subprocess-exited-with-error
  
  Getting requirements to build wheel did not run successfully.
  exit code: 1
  
  [3 lines of output]
  setup.py:117: UserWarning: Unable to determine GEOS version. Ensure you have 3.7.2 or later installed, or installation may fail.
    warnings.warn(
  Proj version 7.0.1 is installed, but cartopy requires at least version 8.0.0.
  [end of output]
  
  note: This error originates from a subprocess, and is likely not a problem with pip.
error: subprocess-exited-with-error

Getting requirements to build wheel did not run successfully.
exit code: 1

See above for output.

note: This error originates from a subprocess, and is likely not a problem with pip

betasy

我一般装cartopy都使用lfd的非官方windows编译的二进制包，
而且安装cartopy之前，需要安装一系列的跟地理数据处理有关的包，
包括：GDAL, Fiona, shapely, pyproj, pygeo, geopandas matplotlib等

https://www.lfd.uci.edu/~gohlke/pythonlibs/

qinzhao

先用cmd命令进入到终端，输入指令pip debug --verbose，然后看compatible tags，看支持什么类型的文件，然后去网站https://www.lfd.uci.edu/~gohlke/pythonlibs/下载相应的wheel文件。下载好之后，cd到wheel所在文件的文件夹，然后pip install ****.wheel(下载好的wheel文件名字）

刘郝

在终端输入conda install cartopy

sadf

已解决，感谢各位

handsome11

sadf 发表于 2022-3-22 16:12
已解决，感谢各位

怎么解决的，我也遇到了同样的问题

sadf

handsome11 发表于 2022-3-26 20:10
怎么解决的，我也遇到了同样的问题

我把interpreter环境换成anaconda的就可以添加进去了

努力学习气象人

qinzhao 发表于 2022-3-20 17:22
先用cmd命令进入到终端，输入指令pip debug --verbose，然后看compatible tags，看支持什么类型的文件，然 ...

感谢分享，这个方法可以解决缺少wheel的方法！帮了大忙了！