关于flexpart出现的Segmentation fault (core dumped)问题解决

Gong

前一个帖子我上传的问题，主要是Segmentation fault (core dumped)问题，初步估计是粒子数过多造成的，因此将 PARTS 数目改为较小的值就可以，原来我参考文章的设置，写为了200000，改为20000就运行出来了

root@LAPTOP-HETNQ246:/usr/local/flexpart_v10.4_3d7eebf# ./FLEXPART
Welcome to FLEXPART Version 10.4 (2019-11-12)
FLEXPART is free software released under the GNU General Public License.
FLEXPART WARNING: TIME DIFFERENCE BETWEEN TWO
WIND FIELDS IS BIG. THIS MAY CAUSE A DEGRADATION
OF SIMULATION QUALITY.
NCEP metdata detected


Vertical levels in NCEP data:      41     41

Mother domain:
  Longitude range:    -179.00     181.00   Grid distance:       1.00
  Latitude range :     -90.00      90.00   Grid distance:       1.00

Releasepoints :            1

SPECIES:  24  AIRTRACER   (GAS)
   Wet removal for gases      is turned: OFF
   Dry deposition for gases   is turned: OFF
   Below-cloud scavenging: OFF
   In-cloud scavenging: OFF
Particles allocated (maxpart)  :       100000
Particles released (numpartmax):       200000
Total mass released: 1.0000000E+00
Allocating fields for global output (x,y):           85          65
Allocating fields for nested output (x,y):            0           0
Concentrations are calculated using kernel
Simulated     0.0 hours (            0 s),             0 particles
Global NCEP fields: using cloud water
Global NCEP fields: using cloud water
Atm. mass:    1.76812664E+15
Segmentation fault (core dumped)

Gong

同时非常感谢@雨落森林 前辈的帮助