WRF安装出现问题，无法改变默认值

哈利路亚

安装WRFV3时，执行./configure后，选择支持的平台，我选了7，然后就结束了，嵌套选项根本没有让选择，直接就过去了，不知道是什么原因造成的？以前安装过WRFV3，从来没有遇到这种情况。另外，这次安装WRF前，重装了jasper, libpng, zlib,  不知道此次安装不正常是否跟这个有关？这个问题已经困扰我一两周了，恳请各位大神帮帮忙！
以下是安装时的一部分信息：
Please select from among the following supported platforms.
   1.  Linux i486 i586 i686, gfortran compiler with gcc  (serial)
   2.  Linux i486 i586 i686, gfortran compiler with gcc  (smpar)
   3.  Linux i486 i586 i686, gfortran compiler with gcc  (dmpar)
   4.  Linux i486 i586 i686, gfortran compiler with gcc  (dm+sm)
   5.  Linux i486 i586 i686, g95 compiler with gcc  (serial)
   6.  Linux i486 i586 i686, g95 compiler with gcc  (dmpar)
   7.  Linux i486 i586 i686, PGI compiler with gcc  (serial)
   8.  Linux i486 i586 i686, PGI compiler with gcc  (smpar)
   9.  Linux i486 i586 i686, PGI compiler with gcc  (dmpar)
  10.  Linux i486 i586 i686, PGI compiler with gcc  (dm+sm)
  11.  Linux x86_64 i486 i586 i686, ifort compiler with icc  (serial)
  12.  Linux x86_64 i486 i586 i686, ifort compiler with icc  (smpar)
  13.  Linux x86_64 i486 i586 i686, ifort compiler with icc  (dmpar)
  14.  Linux x86_64 i486 i586 i686, ifort compiler with icc  (dm+sm)
  15.  Linux i486 i586 i686 x86_64, PathScale compiler with pathcc  (serial)
  16.  Linux i486 i586 i686 x86_64, PathScale compiler with pathcc  (dmpar)
Enter selection [1-16] : 7
------------------------------------------------------------------------
Compile for nesting? (0=no nesting, 1=basic, 2=preset moves, 3=vortex following) [default 0]:
Configuration successful. To build the model type compile .
------------------------------------------------------------------------
testing for fseeko and fseeko64
fseeko64 is supported