- 积分
- 693
- 贡献
-
- 精华
- 在线时间
- 小时
- 注册时间
- 2016-5-17
- 最后登录
- 1970-1-1
|
发表于 2019-10-17 12:38:58
|
显示全部楼层
你好!想请教您一个问题,我在安装WRF4.0 的时候,在./configur后遇到了个问题,你在ppt中也有提到,想请问您具体的解决办法。
我遇到的问题是:
Settings listed above are written to configure.wrf.
If you wish to change settings, please edit that file.
If you wish to change the default options, edit the file:
arch/configure.defaults
NetCDF users note:
This installation of NetCDF supports large file support. To DISABLE large file
support in NetCDF, set the environment variable WRFIO_NCD_NO_LARGE_FILE_SUPPORT
to 1 and run configure again. Set to any other value to avoid this message.
Testing for NetCDF, C and Fortran compiler
This installation of NetCDF is 64-bit
C compiler is 64-bit
Fortran compiler is 64-bit
It will build in 64-bit
************************** W A R N I N G ************************************
There are some Fortran 2003 features in WRF that your compiler does not recognize
The IEEE signaling call has been removed. That may not be enough.
*****************************************************************************
*****************************************************************************
This build of WRF will use classic (non-compressed) NETCDF format
您在ppt中提到的是:
编译时间较长(20分钟左右),成功后你可以在 WRF/run/ 下看到3个执行命令:
ndown.exe real.exe wrf.exe 如果三个都有了,标志你WRF编译成功
如果没有。
1,检查你的软件库是否安装好了所需的编译器
2,检查你的环境变量有没有错
3,configure是否选择了正确的选择(很有可能没选对)
|
|